Crank your engine by turning the ignition key.Give the jump starter three to five minutes to provide the dead battery with a surge of power.Turn the jump starter on by pushing the power button.Wiggle the alligator clips slightly as you connect them to make sure they are making a good connection with the battery post.Connect the alligator clip on the negative cable of the jump starter to the negative terminal of your battery.Connect the alligator clip of the positive cable on the jump starter to the positive terminal on the battery. Get your jump starter out of your trunk and make sure the jump starter is turned off before attempting to connect.There should be a plus or minus sign close to the post to indicate plus for positive and minus for negative. Check to see which battery terminal is positive and which terminal is negative.These covers are to protect the post from corrosion so you want to replace them after you crank your engine. You may have to remove a plastic cover that is over the battery posts. You can have a battery that has terminals and posts on the top of the battery, and some batteries have terminals on the side of the battery. Find the battery under the hood and inspect the battery terminals for corrosion.Place the vehicle you need to jump start in park.The following steps should be followed when connecting jump starters.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |